Differences

This shows you the differences between two versions of the page.

--- can:stm32prg [2018/11/19 07:11]
admin
+++ can:stm32prg [2018/11/19 07:24] (current)
admin
@@ Line 83: / Line 83: @@
 {{:stm:stlink_programming_jdrones.jpg?nolink&600|}}
+) Check messages after programming. You should see //Verification... OK// and program checksum messages after successful programming.
+{{:stm:stlink_programming_ok_jdrones.jpg?nolink&600|}}
+This example was made with Gen.Node v2.1 and with uc4h-bootloader-v006-jDrones.bin bootloader firmware. Process to program SLCAN, jD-STM32 Programmer board or any other STM32 based board is equal to this guide.
+If having any errors or problems. Check that your jD-STM32 programmer has latest firmware in and your computer drivers are updated. Also check SWD settings and error messages from below.
 ----