Differences

This shows you the differences between two versions of the page.

--- can:stm32prg [2018/11/19 06:58]
admin
+++ can:stm32prg [2018/11/19 07:04]
admin
@@ Line 55: / Line 55: @@
+) After successful load. ST-Link software will show loaded BIN file on the main screen.
 {{:stm:stlink_load_uc4h_bootloader_jdrones.jpg?nolink&600|}}
+) Connect to target MCU. Open Target / Connect. On this point you need to have your jD-STM32 Programmer connected via USB and also use pogopin board (or similar) and connect it to target boards SWD connector. Using pogopin board, take a look at [[can:stm32prg#connecting_to_target_board|Connecting Target Board]] area on this page.
 {{:stm:stlink_connect_target_mcu_jdrones.jpg?nolink&600|}}
+) After succesful connection
 {{:stm:stlink_connections_ok_jdrones.jpg?nolink&600|}}