User Tools
can:slcan-definition
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
can:slcan-definition [2018/11/22 00:05] olliw |
can:slcan-definition [2018/11/22 00:10] olliw |
||
|---|---|---|---|
| Line 28: | Line 28: | ||
| | EXT5 | External 5V. If the power provided by the USB bus is not sufficient and the CAN bus needs to be powered by the SLCAN adapter, apply power to this port and shorten the BR1 jumper. | | | EXT5 | External 5V. If the power provided by the USB bus is not sufficient and the CAN bus needs to be powered by the SLCAN adapter, apply power to this port and shorten the BR1 jumper. | | ||
| | EC5V | Direct connection to the CAN 5V line. If the power provided by the USB bus is not sufficient and the CAN bus needs to be powered by the SLCAN adapter, apply power to this port but //**keep the BR1 jumper open**//! Use with care. | | | EC5V | Direct connection to the CAN 5V line. If the power provided by the USB bus is not sufficient and the CAN bus needs to be powered by the SLCAN adapter, apply power to this port but //**keep the BR1 jumper open**//! Use with care. | | ||
| - | | SWD | STM32 programming port. Connector pitch is 1.27mm. This port is for uploading the SLCAN firmware. Use the jDrones STM32 Programmer together with the 1.27mm pogopin adapter board to program the SLCAN board. You can get the jDrones STM32 Programmer from [[http://store.jdrones.com/jdrones_stm32_programmer_p/jdstm32prg10.htm|jDrones Store]]. \\ \\ Pin order from left to right: //GND, SWCLK, SWDIO, 3.3V// \\ \\ __**BEWARE** Always check the orientation of the programmer.__ The SWD port is not reverse polarity protected. | | + | | SWD | STM32 programming port. Connector pitch is 1.27mm. This port is for uploading the SLCAN firmware. Use the [[can:stm32prg|jDrones STM32 Programmer]] together with the 1.27mm pogopin adapter board to program the SLCAN board. You can get the jDrones STM32 Programmer from [[http://store.jdrones.com/jdrones_stm32_programmer_p/jdstm32prg10.htm|jDrones Store]]. \\ \\ Pin order from left to right: //GND, SWCLK, SWDIO, 3.3V// \\ \\ __**BEWARE** Always check the orientation of the programmer.__ The SWD port is not reverse polarity protected. | |
| | UART2 | UART port of the MCU. Used only for debugging purposes and requires custom firmware. Normally not in use. | | | UART2 | UART port of the MCU. Used only for debugging purposes and requires custom firmware. Normally not in use. | | ||
can/slcan-definition.txt ยท Last modified: 2018/11/22 00:11 by olliw
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial 4.0 International
